HP P4015n HP LaserJet P4010 and P4510 Series - User Guide - Page 157
Table 10-1, Control-panel messages continued - fuser error
UPC - 883585429325
View all HP P4015n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Table 10-1 Control-panel messages (continued) Control panel message Description Recommended action 40 EMBEDDED I/O BAD TRANSMISSION To continue press OK The connection has been broken between the product and HP Jetdirect print server. Press OK to clear the error message and continue printing. 41.3 UNEXPECTED SIZE IN TRAY For help press alternates with LOAD TRAY XX [TYPE] [SIZE] To use another tray press OK This is typically caused if two or more sheets 1. stick together in the product or if the tray is not properly adjusted. 2. Reload the tray with the correct paper size. Make sure the paper size that is specified in the software program, the printer driver, and the control panel are all the same. 3. Press OK to scroll to TRAY XX SIZE=. Reconfigure the size in a tray so that the product will use a tray that contains the size required for the print job. 4. If the error does not clear, turn the product off and then on. 5. If the message persists, contact an HPauthorized service or support provider. 41.X ERROR For help press A temporary printing error occurred. 1. Press OK. The page containing the error automatically reprints if jam recovery is enabled. alternates with 41.X ERROR To continue press OK 2. Turn the product off and then on. 3. If the message persists, contact an HPauthorized service or support provider. 49.XXXX ERROR To continue turn off then on A critical firmware error has occurred. 1. This error could be caused by several external influences that are not directly 2. related to the product hardware or firmware: ● The computer operating system Turn the product off, leave it off for 20 minutes, and then turn it on. If you can isolate the cause of the error to an external influence, try to resolve the problem by repairing the external component. ● The network connection ● The printer driver 3. If the message persists, contact an HPauthorized service or support provider. ● The software application ● The document file To help isolate the cause of the problem, identify the actions you were performing before the error occurred. 50.X Fuser Error A fuser error has occurred. 1. Turn the product off and then on. For help press 2. If the message persists, contact an HPauthorized service or support provider. 51.XY ERROR A temporary printing error occurred. 1. Turn the product off and then on. For help press alternates with 2. If the message persists, contact an HPauthorized service or support provider. 51.XY ERROR ENWW Interpret control-panel messages 145