HP P6000 HP Y-cable Replacement Instructions (593098-001, June 2011) - Page 1

HP P6500 EVA Controller Y-cable Replacement Instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. WARRANTY INFORMATION To obtain a copy of the warranty for this product, see the warranty information website: http://www.hp.com/go/storagewarranty © Copyright 2011 Hewlett-Packard Development Company, L.P. First edition: May 2011 The information in this document is subject to change without notice. Printed in Puerto Rico www.hp.com Before you begin Observe the following precautions when replacing the Y-cable: • Ensure that the array is either operational and stable on the redundant path for the device ports being serviced or the array has been shut down. • Label the replacement cable before installing it. See Labeling the replacement Y-cable. NOTE: The Y-cable is replaced as part of the troubleshooting process to address a communication failure. Labeling the replacement Y-cable Before you remove the cable, label the replacement cable with the port numbers using the label kit that shipped with the cable. Four sheets of labels (two red and two green) contain all the port numbers you need. Label the new cable to match the port labels on the original cable. The replacement cable should resemble Figure 1. *593098-001* Page 1