HP PSC 2170 HP PSC 2170 series all-in-one - (English) Setup Poster - Page 1

START HERE 1 Turn on your PC 2 Install the software first Windows 98, 2000, ME, XP Windows desktop a Turn your PC on and wait for the Windows desktop to appear. b Close any open programs, including viruschecking programs. a Insert the HP PSC software CD. b Follow the onscreen instructions. Make sure you are using the correct side of the poster. Windows users: Follow the steps in order. Do not connect the USB cable until instructed to do so. See your box for exact contents and system requirements. 3 Attach the cover a b 5 Connect the power cord and USB cable a b 4 Remove output tray and load paper a Insert the two bottom tabs of the cover into the slots on the unit. b Tilt the cover down and press firmly. Make sure the tabs lock into place and the cover is even with the device. b a Do not connect the USB cable until you see the screen in Step 2. Do not connect the USB cable to a keyboard or non-powered hub. c When prompted to plug in the device (as shown to the left), go to step 3. Return to your computer in step 9. If nothing appears on your computer screen after inserting the CD, search for setup.exe on the CD and double-click the file. Use blank white paper to prepare for print alignment. c d 6 Turn on your HP PSC e Turn power On and wait for display prompt. Note: See the reference guide for adjusting the display viewing angle. Windows setup poster hp psc 2170 series all-in-one 7 Insert and align the print cartridges Make sure to remove any packing material from inside the device. c Black label (56) e a b d Color label (57) f latches a Lift the print carriage door up until it catches. Wait for the print carriage to move to the center. Lift the blue and gray latches. b Remove the bright pink tape from the print cartridges. Do not touch the gold-colored contacts or retape the cartridges. c Hold the black print cartridge with the label on top as shown. Slide the cartridge into the right (gray latch) side of the print carriage. d Hold the color print cartridge with the label on top as shown. Slide the cartridge into the left (blue latch) side of the print carriage. e Pull the end of the gray latch toward you, press down until it stops, and then release. Make sure the latch catches below the bottom tabs. Repeat with the blue latch. f Make sure both latches are locked into position. Close the door. 8 Finish software setup Look at the screen with the green checkmark, and then continue. If you see the screen with the red "X", follow the instructions in the Readme. g 9 Try your new HP PSC g Press Enter on the front panel to begin alignment. After a page prints, alignment is complete. Discard or recycle this page. Congratulations! You are now ready to use the HP PSC. Double-click the Director icon to get started. Make sure there are five icons in the HP Director window. If not, see the reference guide. www.hp.com/support Copyright Hewlett-Packard Company 2003 Printed in USA, Mexico, Germany, and Singapore.