HP PSC 2170 HP PSC 2170 series all-in-one - (English) Setup Poster - Page 2

*Q3066-90192* *Q3066-90192* Q3066-90192 1 Attach the cover a b Macintosh® OS 9, OS X 3 Connect the USB cable Make sure you are using the correct side of the poster. See your box for exact contents and system requirements. Windows users: see other side. If you have an iMac, your USB port is on the side. Do not connect the HP PSC to a USB port on a keyboard or non-powered USB hub. See the reference guide for more details. 6 Insert and align the print cartridges Make sure to remove any packing material from inside the device. a b latches a Insert the two bottom tabs of the cover into the slots on the device. b Tilt the cover down and press firmly. Make sure the tabs lock into place and the cover is even with the device. 2 Remove output tray and load paper Use blank white paper to prepare for print alignment. b a c 4 Connect the power cord d e 5 Turn on your HP PSC c Black label (56) e d Color label (57) f g Macintosh setup poster hp psc 2170 series all-in-one a Lift the print carriage door up until it catches. Wait for the print carriage to move to the center. Lift the blue and gray latches. b Remove the bright pink tape from the print cartridge. Do not touch the gold-colored contacts or retape the cartridges. 7 Install the software c Hold the black print cartridge with the label on top as shown. Slide the cartridge into the right (gray latch) side of the print carriage. d Hold the color print cartridge with the label on top as shown. Slide the cartridge into the left (blue latch) side of the print carriage. e Pull the end of the gray latch toward you, press down until it stops, and then release. Make sure the latch catches below the bottom tabs. Repeat with blue latch. f Make sure both latches are locked into position. Close the door. 8 Try your new HP PSC a Turn your Macintosh on and wait for your Macintosh to finish starting up. Insert the HP PSC software CD. b Double-click the HP All-InOne Installer icon on your desktop. hp_all-in-one_installer c Follow the onscreen instructions. You may have to restart your Macintosh during setup. Be sure to complete the setup assistant. g Press Enter on the front panel to begin alignment. After a page prints, alignment is complete. Discard or recycle this page. Check the reference guide for other ways to get started with your HP PSC. The reference guide also provides instructions for changing the viewing angle on the display.