HP Pavilion 570-p000 Memory Module Replacement Instructions
HP Pavilion 570-p000 Manual
 |
View all HP Pavilion 570-p000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Pavilion 570-p000 manual content summary:
- HP Pavilion 570-p000 | Memory Module Replacement Instructions - Page 1
Memory Module Replacement Instructions 904513-121 Before you begin Observe the following computer before touching any internal parts or electronic components. Tools needed Phillips #2 screwdriver Troubleshooting If the computer displays a memory error after you have turned it back on, - HP Pavilion 570-p000 | Memory Module Replacement Instructions - Page 2
2. To remove the access panel, loosen the captive Phillips screw (1), slide the access panel back, and the lift it off the computer (2). 3. Locate the memory modules: 1. Hard drive 2. Optical drive 3. Memory modules 4. Open both latches of the memory module socket (1), and then lift the module - HP Pavilion 570-p000 | Memory Module Replacement Instructions - Page 3
Replacing the memory module 1. Open both latches of the memory module socket (1), and then insert the memory module into the socket (2). Push the module down into the socket, ensuring that the module is fully inserted and properly seated. Make sure the latches are in the closed position (3). NOTE: - HP Pavilion 570-p000 | Memory Module Replacement Instructions - Page 4
Instructions pour le remplacement d'un module mémoire Avant de commencer Respectez la mémoire utilise deux canaux, vous devez utiliser le même type de module mémoire pour les deux supports. REMARQUE : La vitesse de transfert de mémoire réelle peut varier en fonction du processeur utilisé sur votre - HP Pavilion 570-p000 | Memory Module Replacement Instructions - Page 5
ordinateur (2). 3. Repérez les modules mémoire : 1. Disque dur 2. Lecteur optique 3. Modules mémoire 4. Ouvrez les deux loquets du support de module mémoire (1), et sortez le module du support (2). Utilisez la même procédure pour retirer tous les modules mémoire. 5. Mettez en contact le paquet du - HP Pavilion 570-p000 | Memory Module Replacement Instructions - Page 6
deux loquets du support de module mémoire (1), puis insérez le module dans le support (2). Appuyez sur le HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP
-
1 -
2 -
3 -
4 -
5 -
6
 |
 |
904513-121
1
Memory Module Replacement
Instructions
Before you begin
Observe the following requirements before removing and
replacing memory.
WARNING
: Never open the cover while the power cord
is attached. You might damage your computer or be
injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges inside the
computer.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static electricity
by touching the metal cage of the computer before touching
any internal parts or electronic components.
Tools needed
Phillips #2 screwdriver
Troubleshooting
If the computer displays a memory error after you have
turned it back on, turn the computer off and unplug the
power cord. Open up the memory compartment and make
sure the memory module is inserted all the way into the slot,
and then press down on it to be sure it is firmly seated.
Memory compatibility
The computer uses either SODIMMs (small outline dual-
inline memory modules) or DIMMs (dual-inline memory
modules).
SODIMMs must meet the following requirements:
●
204-pin
●
DDR3L-1600
●
Unbuffered, non-ECC (64-bit)
●
1.35 V
●
8 GB maximum installable memory
DIMMs must meet the following requirements:
●
240-pin
●
DDR3-1600
●
Unbuffered, non-ECC (64-bit)
●
1.5 V
●
16 GB maximum installable memory
Because the memory uses dual channels, you must use the
same memory module type for both sockets.
NOTE
: The actual memory transfer speed might vary,
based on the processor used in your computer.
NOTE
: Memory performance might vary due to different
system configurations.
Removing the memory module
1.
Disconnect the power cord and all attached cables
from the back of the computer.
904513-121