HP Pavilion 570-p000 Memory Module Replacement Instructions - Page 1
HP Pavilion 570-p000 Manual
View all HP Pavilion 570-p000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Memory Module Replacement Instructions 904513-121 Before you begin Observe the following requirements before removing and replacing memory. WARNING: Never open the cover while the power cord is attached. You might damage your computer or be injured by the spinning fan blades. WARNING: Avoid touching sharp edges inside the computer. CAUTION: Static electricity can damage the electronic components inside the computer. Discharge static electricity by touching the metal cage of the computer before touching any internal parts or electronic components. Tools needed Phillips #2 screwdriver Troubleshooting If the computer displays a memory error after you have turned it back on, turn the computer off and unplug the power cord. Open up the memory compartment and make sure the memory module is inserted all the way into the slot, and then press down on it to be sure it is firmly seated. DIMMs must meet the following requirements: ● 240-pin ● DDR3-1600 ● Unbuffered, non-ECC (64-bit) ● 1.5 V ● 16 GB maximum installable memory Because the memory uses dual channels, you must use the same memory module type for both sockets. NOTE: The actual memory transfer speed might vary, based on the processor used in your computer. NOTE: Memory performance might vary due to different system configurations. Removing the memory module 1. Disconnect the power cord and all attached cables from the back of the computer. Memory compatibility The computer uses either SODIMMs (small outline dualinline memory modules) or DIMMs (dual-inline memory modules). SODIMMs must meet the following requirements: ● 204-pin ● DDR3L-1600 ● Unbuffered, non-ECC (64-bit) ● 1.35 V ● 8 GB maximum installable memory 904513-121 1