HP Pro 3380 HP Pro 3330 Microtower PC, HP Pro 3330 Small Form Factor PC, and H - Page 109
attached to the expansion card.
View all HP Pro 3380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
To remove, replace, or add an expansion card: 1. Prepare the computer for disassembly (Preparation for Disassembly on page 90). 2. Remove the access panel (Access Panel on page 90). 3. Locate the correct vacant expansion socket on the system board and the corresponding expansion slot on the back of the computer chassis. 4. Release the slot cover bracket by removing the screw that secures the bracket, and then lifting the bracket off the computer. Figure 8-10 Opening the expansion slot bracket 5. Before installing an expansion card, remove the expansion slot cover or the existing expansion card. NOTE: Before removing an installed expansion card, disconnect any cables that may be attached to the expansion card. a. If you are installing an expansion card in a vacant socket, remove the appropriate expansion slot cover on the back of the chassis. Pull the slot cover straight up then away from the inside of the chassis. Expansion Card 99