HP Pro 3380 HP Pro 3330 Microtower PC, HP Pro 3330 Small Form Factor PC, and H - Page 64
carefully rock it back and forth until the connectors pull free from the socket. Pull
View all HP Pro 3380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
5. Before installing an expansion card, remove the expansion slot cover or the existing expansion card. NOTE: Before removing an installed expansion card, disconnect any cables that may be attached to the expansion card. a. If you are installing an expansion card in a vacant socket, you must remove the metal slot cover on the rear panel that covers the expansion slot. Be sure to remove the appropriate slot cover for the expansion card you are installing. b. If you are removing a standard PCI card or a PCIe x1 card, hold the card at each end, and carefully rock it back and forth until the connectors pull free from the socket. Pull the expansion card straight up from the socket then away from the inside of the chassis to release it from the chassis frame. Be sure not to scrape the card against the other components. Figure 7-11 Removing a PCI expansion card - PCIe x1 card shown 54 Chapter 7 Removal and Replacement Procedures - Microtower (MT) Chassis