HP Pro Tower 400 G9 PCI Desktop PC Maintenance and Service Guide - Page 41
Solid-state drive
View all HP Pro Tower 400 G9 PCI Desktop PC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
3. Remove the optical drive (see Optical drive on page 22). 4. Remove the front bezel (see Front bezel on page 24). Remove the drive cage: 1. Remove the Torx screw from the front of the computer (1). 2. Lift the tab on the inside-left of the drive cage (2) and rotate the cage upward to approximately 50-60° (3). 3. Remove the drive cage (4). To remove the drive cage down, reverse this step. Solid-state drive To remove the solid-state drive module, use these procedures. Before removing the solid-state drive module, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 19). 2. Remove the access panel (see Access panel on page 19). 3. Remove the optical drive (see Optical drive on page 22). 4. Remove the drive cage (see Drive cage on page 33). Remove the solid-state drive module: 1. Remove the screw that secures the drive. NOTE: System board appearance might vary. 34 Chapter 4 Removal and replacement procedures