HP ProLiant SL4540 HP ProLiant SL4540 Gen8 Server Node User Guide - Page 35
Advanced ECC memory configuration, General DIMM slot population guidelines
View all HP ProLiant SL4540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Advanced Memory Protection options are configured in RBSU. If the requested AMP mode is not supported by the installed DIMM configuration, the node boots in Advanced ECC mode. For more information, see "HP ROM-Based Setup Utility (on page 52)." Maximum capacity DIMM type RDIMM RDIMM DIMM rank Single-rank Dual-rank One processor 24 GB 96 GB Two processors 48 GB 192 GB For the latest memory configuration information, see the QuickSpecs on the HP website (http://www.hp.com). Advanced ECC memory configuration Advanced ECC memory is the default memory protection mode for this node. Standard ECC can correct single-bit memory errors and detect multi-bit memory errors. When multi-bit errors are detected using Standard ECC, the error is signaled to the node and causes the node to halt. Advanced ECC protects the node against some multi-bit memory errors. Advanced ECC can correct both single-bit memory errors and 4-bit memory errors if all failed bits are on the same DRAM device on the DIMM. Advanced ECC provides additional protection over Standard ECC because it is possible to correct certain memory errors that would otherwise be uncorrected and result in a node failure. Using HP Advanced Memory Error Detection technology, the node provides notification when a DIMM is degrading and has a higher probability of uncorrectable memory error. General DIMM slot population guidelines Observe the following guidelines for all AMP modes: • Install DIMMs only if the corresponding processor is installed. • When two processors are installed, balance the DIMMs across the two processors. • White DIMM slots denote the first slot of a channel (Ch 1-A, Ch 2-B, Ch 3-C). • When one processor is installed, install DIMMs in sequential alphabetic order: A, B, C, D, E, and F. • When two processors are installed, install the DIMMs in sequential alphabetic order balanced between the two processors: P1-A, P2-A, P1-B, P2-B, P1-C, P2-C, and so forth. • For DIMM spare replacement, install the DIMMs per slot number as instructed by the system software. For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool on the HP website (http://www.hp.com/go/ddr3memory-configurator). Advanced ECC population guidelines For Advanced ECC mode configurations, observe the following guidelines: • Observe the general DIMM slot population guidelines (on page 35). • DIMMs may be installed individually. Hardware options installation 35