HP Slate 21-s100 HP Slate 21 All-in-One User Guide - Page 10
Setting up the hardware, Preparing for desk use, Preparing for wall mounting - desktop
View all HP Slate 21-s100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
2 Setting up the hardware You can install the all-in-one on a desktop or mount it to a mounting fixture such as a wall mount or swing arm. Be sure to place the all-in-one in a convenient, well-ventilated location. Connect the cables after you have installed the all-in-one to a mounting fixture. To set up the all-in-one, ensure that the power is turned off to the all-in-one and all attached accessories, and then follow the instructions below for your configuration. Preparing for desk use To assemble the all-in-one for desktop use: 1. Set the all-in-one face down on a flat, soft, protected table or desk surface. 2. Pull the stand outward until you hear it click. 3. Lift the all-in-one to an upright position and place on a flat, stable surface. Preparing for wall mounting NOTE: This all-in-one is intended to be supported by UL or CSA Listed wall mount bracket. You can only VESA mount the all-in-one in landscape orientation with the rear ports facing down. Do not place in portrait orientation. To attach the all-in-one to a mounting fixture: 1. Set the all-in-one face down on a flat, soft, protected table or desk surface. 4 Chapter 2 Setting up the hardware