HP StorageWorks 1000 HP StorageWorks 1000 Modular Smart Array installation gui - Page 37
Step 6: Prepare your servers, Table 12, Server information - modular smart array quickspecs
View all HP StorageWorks 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Step 6: Prepare your servers In an existing SAN, the servers are already set up and configured, but if you are deploying your MSA in a new SAN, install and configure your servers at this time. HP recommends that you: • Verify that the servers and operating systems you plan to use are supported for use with the MSA. For a list of servers and operating systems that are supported for use with the MSA, see the MSA compatibility guide and the QuickSpecs, located on the QuickSpecs and Technical documentation pages of the MSA1000 website: http://www.hp.com/go/msa1000 . • Designate one of the servers as a management server, if more than one server will access the MSA. It is on the management server that you install management software (such as the ACU) and it is from this server that you perform your SAN management tasks. (Instructions for installing the ACU are included later in this guide.) • Verify that all servers that will access the MSA are functioning properly before proceeding to the next step in this guide. • Install the latest available operating system updates and patches. For a list of operating systems versions that are supported for use with the MSA see the compatibility guide, located on the Technical documentation page of the MSA1000 website: http://www.hp.com/go/msa1000 . NOTE: In multipath configurations, management software such as the ACU must be installed on each server with access to the MSA. For information about installing and configuring your servers, refer to the instructions that came with your server and operating system. Go to Table 12: "Server information" on page 108 to record information about the servers that will connect to the MSA. HP StorageWorks 1000 Modular Smart Array installation guide 37