HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 500
portCmd, Synopsis, Description, Operands
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 500 highlights
2 Note: Enter commands in lowercase only; mixed case is for readability. portCmd portCmd Diagnoses intelligent ports. Synopsis portcmd --ipperf [slot/]geport -s src_ip -d dst_ip -S | -R [-i interval] [-p port] [-r committed_rate] [t running_time] [-z size] portcmd --ping [slot/]geport -s src_ip -d dst_ip [-n num_requests] [-q service_type] [-t ttl] [-w wait_time] [-z size] portcmd --traceroute [slot/]geport -s src_ip -d dst_ip [-h max_hops] [-f first_ttl] [-q type_of_service] [-w timeout] [-z size] Description Use this command to invoke the end-to-end IP path performance (ipperf) characterization feature or to ping, or trace route to a destination IP host from an intelligent GbE port. Currently we do not support end-to-end path characterization if there exists an IPSec-enabled tunnel using the same source/local IP address. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: slot For bladed systems only, specifies the slot number. geport Specifies the port number of the GbE port on the blade. --ipperf [slot/]geport -s src_ip -d dst_ip -S | -R [-i interval] [-p port] [-r committed_rate] [-t running_time] [-z size] Determines the path characteristics to the remote host. Valid arguments include: -s src_ip Specifies the local IP address to use for sourcing the probe packets. ipperf will not start if there exists an IPSec-enabled tunnel using the same source IP address. -d dst_ip Specifies the destination IP address to which to probe the IP router path. -S Specifies the source mode to initiate the TCP connection. The source end-point generates a traffic stream and reports to the end-to-end IP path characteristics from this end-point toward the receiver end-point sink. -R Specifies the sink mode to accept the new connection. The end-to-end path characteristics are not reported. -i interval Specifies the intervals between polling and displaying stats, in seconds. If the duration is less than -t running_time, the stats displays only once, at the conclusion of the test. This operand is optional. -p port Specifies the TCP port number for the listener end-point. This operand is optional. 2-466 Fabric OS Command Reference Manual Publication Number: 53-1000240-01