HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 77
bladeDisable, Synopsis, Description, Operands, Examples, See Also
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Note: Enter commands in lowercase only; mixed case is for readability. bladeDisable 2 bladeDisable Disables all user ports on a blade. Synopsis bladedisable slotnumber Description Use this command to disable all user ports on a blade. All ports on the blade are taken offline. If the switch was connected to a fabric through this blade, the remaining switches reconfigure, and this switch will configure based on the other blade ports. The blade must be disabled before making configuration changes or before running many of the diagnostic tests. The blade does not need to be disabled before rebooting or powering off. Observe and verify the disable process by watching the front panel LEDs change to slow flashing yellow as each port of the blade disables. Note A blade cannot be disabled or enabled when the switch is disabled or when the blade itself is faulted, powered off, or running diagnostics. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands Examples This command has the following operand: slotnumber Specify the slot number on which the ports are to be disabled. To disable blade 2 and then verify: switch:admin> bladedisable 2 Blade 2 is being disabled...Done switch:admin> slotshow Slot Blade Type ID Status 1 SW BLADE 2 ENABLED 2 SW BLADE 2 ENABLED (User Ports Disabled) 3 SW BLADE 2 ENABLED 4 SW BLADE 2 ENABLED 5 CP BLADE 1 ENABLED 6 CP BLADE 1 ENABLED 7 SW BLADE 2 ENABLED 8 SW BLADE 2 ENABLED 9 SW BLADE 2 ENABLED 10 SW BLADE 2 ENABLED See Also bladeEnable, portDisable, portEnable, switchShow Fabric OS Command Reference Manual Publication Number: 53-1000240-01 2-43