HP StorageWorks 3000 Compaq StorageWorks RAID Array 3000 for Windows NT-Intel - Page 3

Release Notes Supported Devices Software Version 1.1, under Windows NT 3.51, 4.0, supports the devices listed in Table 4 at the indicated hardware and Microcode levels or higher. Table 4 Supported Disk Drives Part Number DS-RZ1CF-VW DS-RZ1DF-VW DS-RZ1EF-VW DS-RZ1CD-VW DS-RZ1DD-VW DS-RZ1ED-VW DS-RZ1BB-VW DS-RZ1CB-VW DS-RZ1DB-VW DS-RZ1DA-VW DS-RZ1EA-VW DS-RZ1FB-VW Description 4.3GB, 7200RPM disk in 3.5"SBB 9.1GB, 7200RPM disk in 3.5"SBB 18.2GB, 7200RPM disk in 3.5"SBB 4.3GB, 10000RPM disk in 3.5"SBB 9.1GB, 10000RPM disk in 3.5"SBB 18.3GB, 10000RPM disk in 3.5"SBB 4.3GB, 7200RPM disk in 3.5"SBB 9.1GB, 7200RPM disk in 3.5"SBB 9.2GB, 7200RPM disk in 3.5"SBB 9.1GB, 7200RPM disk in 3.5"SBB 18.2GB, 7200RPM disk in 3.5"SBB 36.4GB, 7200RPM disk in 3.5"SBB Minimum Firmware Level 0371/N1H1/1614 0371/N1H1/1614 0371/N1H1 0306 0306 0306 LYJ0/0658 LYJ0/0658 LYJ0/0658 3B05 3B05 3B05 On-line Documentation Your RAID Array 3000 reference manuals are part of the RAID Array 3000 V1.2 for Windows NT -Intel CD-ROM. They can be viewed and printed using Adobe Acrobat Reader when installed on an Intel-based Windows platform. A copy of the reader is included in the CD-ROM for your convenience. RAID Array 3000 Operating Constraints Controller Always Operate Your RAID Array 3000 with the UPS-to-Pedestal Serial Cable Connected The UPS serial cable must be connected at all times. This cable is used to communicate a power failure to the controller. When the controller senses a power failure, it automatically saves your data to disk. The purpose of the UPS is to keep your system running until the controller accomplishes its task of saving cache data to disk. Wait Until the Disk Drive Fault Indicator Clears Before Using the Disk Disk Drive fault LED clearing takes approximately two minutes. Do not attempt to use a disk drive until its fault indicator turn off. AA-RADOC-TE 3