HP StorageWorks 4/256 Brocade Access Gateway Administrator's Guide v6.2.0 (53- - Page 43
Category, Description, I refers to Index and D, I refers to Domain, Index.
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Access Gateway trunking 2 TABLE 6 Category Access Gateway trunking considerations for the Edge switch Description PID format Long Distance F_Port masterless trunking is only supported in CORE PID format. Long distance is not allowed on F_Port trunks, which means a Trunk Area is not allowed on long distance ports; you cannot enable long distance on ports that have a Trunk Area assigned to them. Port mirroring Port mirroring is not supported on Trunk Area ports or on the PID of an F_Port trunk port. configdownload If you issue the configdownload command for a port configuration that is not compatible with F_Port trunking, and the port is Trunk Area enabled, then the port will be persistently disabled. ICL Port AD DCC Policy D.I. Zoning (D,I) AD (D, I) DCC and (PWWN, I) DCC Note: Configurations that are not compatible with F_Port trunking are long distance, port mirroring, non-CORE_PID, and Fastwrite. F_Port trunks are not allowed on ICL Ports. The porttrunkarea command does not allow it. You cannot create a Trunk Area on ports with different Admin Domains. You cannot create a Trunk Area in AD255. DCC policy enforcement for the F_Port trunk is based on the Trunk Area; the FDISC requests to a trunk port is accepted only if the WWN of the attached device is part of the DCC policy against the TA. The PWWN of the FLOGI sent from the AG will be dynamic for the F_Port trunk master. Because you do not know ahead of time what PWWN AG will use, the PWWN of the FLOGI will not go through DCC policy check on an F_Port trunk master. However, the PWWN of the FDISC will continue to go through DCC policy check. Creating a Trunk Area may remove the Index ("I") from the switch to be grouped to the Trunk Area. All ports in a Trunk Area share the same "I". This means that Domain,Index (D,I), which refer to an "I", that might have been removed, will no longer be part of the switch. Note: Ensure to include AD, zoning and DCC when creating a Trunk Area. You can remove the port from the Trunk Area to have the "I" back into effect. D,I will behave as normal, but you may see the effects of grouping ports into a single "I". Also, D,I continues to work for Trunk Area groups. The "I" can be used in D,I if the "I" was the "I" for the Trunk Area group. Two masters QoS Note: "I" refers to Index and D,I refers to Domain,Index. Two masters is not supported in the same F_Port trunk group. Not currently supported. Access Gateway Administrator's Guide 25 53-1001189-01