HP StorageWorks 4/256 Brocade Error Message Reference Guide v6.0.0 (53-1000600 - Page 96
AUTH-1040, Check the shared secrets using
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
3 AUTH-1040 Recommended Correct the switch policy configuration on either of the switches using the authUtil command, and Action then enable the port using the portEnable command. Severity ERROR AUTH-1040 Message , [AUTH-1040], ,, INFO, , Reject authentication on port , because switch authentication policy is set to OFF. Probable Cause Indicates that the local switch has rejected the authentication because the switch policy is turned off. If the neighboring switch has a strict (ON) switch policy, the light will go off due to conflicting configuration settings. Otherwise E_Port will form without authentication. Recommended Action If there is no light on the port, correct the switch policy configuration on either of the switches using the authUtil command, and then enable the port on the neighboring switch using the portEnable command. If the E_Port formed, no action is required. Severity INFO AUTH-1041 Message , [AUTH-1041], ,, ERROR, , Port has been disabled, because an authentication-reject was received with code '' and explanation ''. Probable Cause The specified port had been disabled, because it received an authentication-reject response from the connected switch/device. The error might indicate that an invalid entity attempted to connect to the switch. Recommended Action Check the connection port for a possible security attack. Check the shared secrets using secAuthSecret and reinitialize authentication using the portDisable and portEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1042 Message Probable Cause , [AUTH-1042], ,, ERROR, , Port has been disabled, because authentication failed with code '' and explanation ''. The specified port has been disabled, because the connecting switch/device failed to authenticate. The error might indicate that an invalid entity attempted to connect to the switch. 44 Fabric OS Message Reference 53-1000600-01