HP StorageWorks 4/256 Brocade Error Message Reference Guide v6.1.0 (53-1000600 - Page 115
BM System Messages, BM-1001
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
BM System Messages Chapter 7 BM-1001 Message , [BM-1001], ,, ERROR, , BM protocol version in slot . Probable Cause Indicates that the software running on the CP cannot communicate with the AP blade in the indicated slot, in order to determine AP blade's firmware version. This can be due to one of the following: • The CP blade is running a later version than the AP blade. • The CP blade is running a much older version than the AP blade. Recommended Action The problem can be corrected by changing the firmware version on either the control processor (CP) or on the application processor (AP) blade. The firmware version on the CP blade can be changed using the firmwareDownload command. Refer to the release notes to determine whether a non-disruptive firmware download is supported between the versions. As the AP and CP blades cannot communicate, it is not possible to load new firmware on the AP blade. If needed, send the AP blade back to the factory for a firmware update. Severity ERROR BM-1002 Message , [BM-1002], ,, INFO, , Connection established between CP and blade in slot . Probable Cause The control processor (CP) has established a connection to the blade processor (BP) and can communicate. Recommended No action is required. Action Severity INFO BM-1003 Message Probable Cause , [BM-1003], ,, WARNING, , Failed to establish connection between CP and blade in slot . Faulting blade. The control processor (CP) could not establish a connection to the blade processor (BP) to communicate. Fabric OS Message Reference 63 53-1000600-02