HP StorageWorks 4/64 Brocade Troubleshooting and Diagnostics Guide v6.1.0 (53- - Page 57
Scenario, Error handling, Required Action, to reboot or unable
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Brocade DCX error handling 5 TABLE 9 Brocade DCX CP Error Handling Scenario When No. Scenario Error handling Required Action 7 During When downloading to 1. When the co-CPU on the standby CP Restart step 7 the co CPU of the boots up, firmwareDownload is firmwareDownload standby CP, if an error aborted. after the repair is occurs and the co CPU reboots. 2. The firmwareCommit command will be initiated on both CPUs on both done. CPs. 3. Both CPUs on the standby CP will have the old firmware and both CPUs on the active CP will have the new firmware. 8 During When downloading to 1. The firmwareCommit command will Restart step 6 or any of the CPUs on the be initiated on both CPU on both CPs. firmwareDownload 7 standby CP, 2. Both CPUs on the standby CP will after the repair is downloading takes too long and exceeds the 30 minute timeout for the firmwareDownload have the old firmware and both CPUs on the active CP will have the new firmware. done. process. 9 During The active CP fails over 1. The standby CP will become the new Restart step 6 or during the downloading active CP. firmwareDownload 7 to any of the CPUs on the standby CP. 2. The firmwareCommit command will be initiated on both CPUs on the after the repair is done. active CP and they will have the old firmware. 3. The firmwareCommit will be initiated on both CPUs on the standby CP and they will have the new firmware. 10 During If the standby CP failed 1. Active CP will wait for 10 minutes and Determine why the step 8 to reboot or unable to abort firmwareDownload. CPs fail to gain HA synchronize with the active CP. 1 The firmwareCommit command will be initiated on both CPUs and they will have the new firmware. sync and remedy it before restarting the firmwareDownload 2. If the standby CP boots up, command. firmwareCommit will start on both CPUs and they will have new firmware. 11 During If commit fails step 10 The affected CPUs will have different versions of firmware on its partitions. An error message is logged. Run the firmwareCommit -f command on the switch or each CP that fails. If the problem persists, contact your switch support provider. Fabric OS Troubleshooting and Diagnostics Guide 43 53-1000853-01