HP StorageWorks 4/8 HP StorageWorks Fabric OS 6.0.1a release notes (AA-RWFMA-T - Page 23
Fabric OS 6.0.1 fixes, Table 9 Fabric OS 6.0.1 closed defects
View all HP StorageWorks 4/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Fabric OS 6.0.1 fixes Table 9 lists defects closed in the Fabric 6.0.1 firmware release. Table 9 Fabric OS 6.0.1 closed defects Closed defect summary Solution Device connected to embedded Access Gateway edge switch fails to see storage in a HP B-series fabric. Fixed in Fabric OS 6.0.1 400 MP Router sends wrong sense code (x80) during tape backup when pipelining enabled. Fixed in Fabric OS 6.0.1 Slow security sync dump caused Hot Code Load (HCL) to be disruptive on DC SAN Backbone Director. Fixed in Fabric OS 6.0.1 DC SAN Backbone Director can panic due to race condition. Fixed in Fabric OS 6.0.1 FICON PTP VTS Selective Resets and Aborted sequences caused by incorrect entry into FICON tape read pipelining. Fixed in Fabric OS 6.0.1 Ex_Port fails to come online after downgrading firmware from Fabric OS 6.x to Fabric OS 5.3 if there is no EX_Port on the switch prior to downgrade. Fixed in Fabric OS 6.0.1 Under some rare conditions, DC SAN Backbone Director detects and posts fan fault error messages when there is no fan fault. Fixed in Fabric OS 6.0.1 Serdes settings revised for Finisar 8Gb SFP+ in order to improve margins. Fixed in Fabric OS 6.0.1 Under rare conditions, the DC SAN Backbone Director panics when the software watchdog detects an unexpected termination of the FICON CUP daemon (ficud). Fixed in Fabric OS 6.0.1 Sensors show incorrect command output in DC SAN Backbone Director when fully loaded with 8 FC8-48 blades. Fixed in Fabric OS 6.0.1 In a FICON environment with an extender, if a host path on the extender goes offline it will not recover. Fixed in Fabric OS 6.0.1 During fast_write (tape_pipelining) with 400 MP Router, tape gets marked as full prematurely. Fixed in Fabric OS 6.0.1 Fabric OS 6.0.1a fixes Table 10 lists defects closed in this Fabric OS 6.0.1a firmware release. Table 10 Fabric OS 6.0.1a closed defects Closed defect summary Solution DC SAN Backbone Director panic occurs during change of F_Port to E_Port in soft zone configuration. Fixed in Fabric OS 6.0.1a HP StorageWorks Fabric OS 6.0.1a release notes 23