HP StorageWorks 8/20q HP StorageWorks 8/20q and SN6000 Fibre Channel CIM Agent - Page 18
QLGC_FCPortSettings : CIM_FCPortSettings, Opaque Identifier
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
QLGC_FCPortSettings : CIM_FCPortSettings There is an instance of FCPortSettings for every port on the switch hosting the CIM Agent. This class is used to change the port configuration used on reset and startup. Changing the configuration also causes the current port settings to be set to the new configured value. Supported properties and methods InstanceID Opaque Identifier ElementName Property contains the string FC Port Settings. RequestedSpeed Property contains the configured port speed. This value is ignored if the AutoSenseSpeed property is TRUE. The active port speed is reported in the FCPort.Speed property. Valid values are reported by the RequestedSpeedsSupported property of the corresponding FCPortCapabilities instance. Possible values are: • 1062500000: 1 Gb/s • 2125000000: 2 Gb/s • 4250000000: 4 Gb/s • 8500000000: 8 Gb/s • 12570000000: 10 Gb/s • 25500000000: 20 Gb/s If AutoSenseSpeed is set to TRUE, changes to this property are ignored. As a result, the AutoSenseSpeed property should be disabled before the RequestedSpeed property is changed, or they should both be changed at the same time. AutoSenseSpeed Property contains a Boolean value indicating if the port is configured to AutoSense the speed. This property overrides the RequestedSpeed property. The active port speed is reported in the FCPort.Speed property. This property may be edited if the value of the EditAutoSenseSpeed property of the corresponding FCPortCapabilities instance is TRUE. RequestedType Property contains the configured port type. The active port type is reported in the FCPort.PortType property. Valid values for this property are reported by the RequestedTypesSupported property of the corresponding FCPortCapabilities instance. Possible values are: • 2-G: Port may act as an E or F port. • 3-GL: Port may act as an E, F, or FL port. • 5-F: Port may only act as an F port. • 6-FX: Port may act as an F or FL port. • 16000-Donor: Port may not connect, it donates its credits for use by another port. Extended properties and methods RequestedIOStreamGuardState Property contains the configured IOStreamGuard state. The operational IOStreamGuard state is reported by the FCPort.IOStreamGuard property. Valid values for this property are reported by the SupportedIOStreamGuardStates property of the corresponding FCPortCapabilities instance. IOStreamGuard should only be enabled for ports that are connected to initiators. Possible values are: • 1-AutoSense: Port will enable IOStreamGuard, if connected to an Initiator. 18 Switch management classes