HP StorageWorks EVA3000 HP StorageWorks 3000/5000 Enterprise Virtual Array upd - Page 37

Step 7. Entering storage system passwords

Get HP StorageWorks EVA3000 PDF manuals and user guides View all HP StorageWorks EVA3000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

Figure 18 Code Load Disk Drives - Page 3 window Upgrading firmware on an individual disk If it is necessary to upgrade the firmware on an individual disk, the firmware and installation instructions can be downloaded from the following web site: http://www.hp.com/support/evadiskfirmware Step 7. Entering storage system passwords Estimated time to complete: 10 minutes NOTE: This step is only required if you use password protection on the storage system. Use the following procedure to add a password to the HSV controller pair. NOTE: When you add a system password to the controller, you must also enable password access in HP Command View EVA. The two work in conjunction with one another. Entering the password on the OCP Using the following procedure to enter the password on the storage system controllers. The password can be entered from either controller. HP StorageWorks 3000/5000 Enterprise Virtual Array updating product software guide (VCS 4.100) 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
Figure 18 Code Load Disk Drives — Page 3 window
Upgrading
fi
rmware on an individual disk
If it is necessary to upgrade the
fi
rmware on an individual disk, the
fi
rmware and installation instructions
can be downloaded from the following web site:
h
t
t
p
:
/
/
w
w
w
.
h
p
.
c
o
m
/
s
u
p
p
o
r
t
/
e
v
a
d
i
s
k
fi
r
m
w
a
r
e
Step 7. Entering storage system passwords
Estimated time to complete:
10 minutes
NOTE:
This step is only required if you use password protection on the storage system.
Use the following procedure to add a password to the HSV controller pair.
NOTE:
When you add a system password to the controller, you must also enable password access in HP
Command View EVA. The two work in conjunction with one another.
Entering the password on the OCP
Using the following procedure to enter the password on the storage system controllers. The password
can be entered from either controller.
HP StorageWorks 3000/5000 Enterprise Virtual Array updating product software guide (VCS 4.100)
37