HP StorageWorks Modular Smart Array 1000 HP StorageWorks 1000/1500 Modular Sma - Page 11

Verifying SAN connectivity Step Description Check 1 For switch fabric SAN connectivity: F • Log on to the switch management utility and verify that the switch fabric is set up properly, including zoning. • From the MSA CLI, enter show this_controller to verify that this MSA array controller is configured for switch fabric connectivity. • From the MSA CLI, enter show other_controller to verify that the other MSA array controller is configured for switch fabric connectivity. Example display: CLI>show this_controller Controller MSA1500(c) Hewlett-Packard P56350A9IMN01Z Version 6.32 Build 1 Hardware 7 Component Enclosure. Controller Identifier: NODE_ID = 500508B3-00909AA0 SCSI_VERSION = SCSI-3 Supported Redundancy Mode:Active/Standby Asym-Active/Active Current Redundancy Mode:Asym-Active/Active Active/Standby Simulation DISABLED Device Port SCSI address 7 Terminal speed for the CLI is set to 19200. Host Port_1: REPORTED PORT_ID 500508B3-00909AA9 PORT_1_TOPOLOGY = F_Port (Switch Fabric Enabled) 2 For direct connect SAN connectivity: F From the MSA CLI of the newly added controller: • Enter show this_controller_hard_address to determine if the MSA array controller is configured for direct connect SAN connectivity. • Enter set this_controller_hard_address to enable hard addressing on the array controller. Example display when hard addressing is disabled: CLI>show this_controller_hard_address Hard Addressing is disabled. Example display of enabling a hard address: CLI>set this_controller_hard_address enable 10 Hard Addressing is enabled. Loop ID=10, AL-PA=0xD5 Negotiated Two Gig Migrating from an active/passive single controller to active/active dual controllers in HP-UX environments 11