HP StorageWorks Modular Smart Array 1000 HP StorageWorks SCSI I/O Module with - Page 1

Replacement Instructions hp StorageWorks SCSI I/O Module with Integrated EMU These instructions apply to the MSA1000 product family. The part may also be used in other HP products. Please refer to documentation for your specific product for detailed replacement instructions. About this document This document details the procedures for replacing a failed SCSI I/O Module with Integrated EMU Indicators in HP StorageWorks Modular Smart Array (MSA) storage systems. Verifying component failure Before replacing the module, use the following methods to verify the component failure. ■ If the EMU indicator on the front panel 1 is not blinking, it indicates a failure. ■ If the fault indicator 3 is amber, it indicates a fault. 1 2 3 If the product in which this part is being replaced is still under HP warranty, then the replacement part(s) referred to in these Replacement Instructions is provided under the terms and conditions of the Hewlett-Packard Company Limited Warranty for that product. A copy of this Limited Warranty may be viewed at: http://h18006.www1.hp.com/products/storageworks/warranty.html If this is a trade sale part (product out of warranty), then the replacement part(s) referred to in these Replacement Instructions is provided under HP's express limited warranty statement, which may be viewed at: http://customerops.corp.hp.com/1sw/pdm_om/warranty_support/policies/ 2330100.doc The replacement part takes on either the Limited Warranty Period of the part being replaced or a ninety-day period that begins upon installation of the replacement part, whichever is greater. The information contained on these replacement instructions is subject to change without notice. The only warranty for this replacement product is as noted above. Nothing in these replacement instructions should be construed as constituting an additional warranty. The information provided in these replacement instructions is provided "AS IS" and HP is not liable for technical or editorial errors or omissions contained herein. © Copyright 2004 Hewlett-Packard Development Company, L.P. Please note that this document is protected by federal copyright law and that no part of this document may be copied, reproduced or translated without the prior written consent of Hewlett-Packard Development Company, L.P. Printed in the USA. SCSI I/O Module with Integrated EMU Indicators Replacement Instructions First Edition (April 2004) Part Number: 358189-001 358189- 001 Figure 1: Front panel LED indicators 1 EMU Indicator 2 Power indicator 15078 3 Fault Indicator ■ If the SCSI I/O Module power indicator 1 is off it indicates a failure. 123 15079 Figure 2: SCSI I/O Module LED indicators 1 Power indicator 2 Port activity 3 Port activity ■ Check the controller LCD for one of the error messages listed in Table 1. Table 1: LCD Error Messages No. 23 311 412 Message SCSI SUBSYSTEM HARDWARE FAILURE EMU FLASH FAILED STORAGE BOX # EMU NOT RESPONDING