HP Surestore 1200ex Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 12

screw on each side panel. This provides a little more room

Page 12 highlights

d. Slide the first drive into the BOTTOM of the drive enclosure. Note If you can't get the drive all the way into the enclosure, loosen the T-10 screws that secure the bottom access panel (one screw on each side panel). This provides a little more room, and the drive will slide right in. Note As the lower and upper drives are placed into the enclosure, you will be removing the adhesive on the drive interface cable clips and attaching the clips to the rear of the lower and upper drives as shown in Figure 9. e. Attach the drive interface cable clips to the lower and upper drives as shown in Figure 9. Figure 9: Placement of drive interface cable clips as drives are mounted f. To the lower drive - Connect the "BOTTOM" drive interface cable. Connect the second to last SCSI connector. Connect the "BOTTOM" power cable. g. Mount the lower drive in the drive enclosure using the 4 T-10 screws supplied. h. Slide the second drive into the top of the drive enclosure. Mount the cables to the drive similar to the lower drive except use the "TOP" drive interface cable. Route the top and bottom power cables OVER the SCSI cable. i. Mount the upper drive in the drive enclosure using the 4 T-10 screws. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15

12
d.
Slide the first drive into the BOTTOM of the drive enclosure.
e.
Attach the drive interface cable clips to the lower and upper drives as shown in Figure 9.
Figure 9:
Placement of drive interface cable clips as drives are mounted
f.
To the lower drive — Connect the “BOTTOM” drive interface cable. Connect the second to last
SCSI connector. Connect the “BOTTOM” power cable.
g.
Mount the lower drive in the drive enclosure using the 4 T-10 screws supplied.
h.
Slide the second drive into the top of the drive enclosure. Mount the cables to the drive similar
to the lower drive except use the “TOP” drive interface cable.
Route the top and bottom power cables OVER the SCSI cable.
i.
Mount the upper drive in the drive enclosure using the 4 T-10 screws.
Note
If you can’t get the drive all the way into the enclosure, loosen
the T-10 screws that secure the bottom access panel (one
screw on each side panel). This provides a little more room,
and the drive will slide right in.
Note
As the lower and upper drives are placed into the enclosure,
you will be removing the adhesive on the drive interface cable
clips and attaching the clips to the rear of the lower and upper
drives as shown in Figure 9.