HP Surestore 1200ex Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 9
half. See
View all HP Surestore 1200ex manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3. If upgrading to an 8- or 12-drive configuration, remove the first available (empty) drive enclosure from the top. If upgrading to a 10-drive configuration, remove the drive enclosure at position #6 (see Figure 1). a. Disconnect the fan power cable from the interposer PCA. b. Remove the 2 T-20 screws from each side of the drive enclosure and remove the drive enclosure. 4. Remove the top cable access panel on the top rear of the drive enclosure. The access panel will rotate out if the 2 T-10 mounting screws on either side of the enclosure are removed. 5. Place the (empty) drive enclosure on its side and trim off the top half of the cable hole edge protector. Use a utility knife to cut through the middle of each side of the edge protector. Remove the top half. See Figure 4. Cutting off this portion of the edge protector allows the L-shaped air seal that will be mounted later to stick, Figure 4: Cutting off the top half of the cable hole edge protector 9