HP Surestore L10 Service and User Manual (Short- and Long-Wave) - Page 85
The hub is automatically rebooted and additional messages appear
View all HP Surestore L10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
After a few minutes, the transfer prompt appears; for example: Done, memory range [$00001000:$00004FFF] Ready to transfer Hub-Controller code from RAM to FLASH Note, once started, this step must not be interrupted Press Enter to start, control-C to cancel The values displayed for memory range represent low-level diagnostics; the values displayed in the status message can be different from the values shown here. 4. Press . Additional progress indicators and status messages appear; for example: The hub is automatically rebooted and additional messages appear: Rebooting to make sure download was successful... DRAM test (this will take about 10 seconds) > passed SEEPROM test (this will take about 1 second ) > passed FLASH checksum (this will take about 2 seconds) > passed Press Enter key for Boot Menu, Agent boot in 6 seconds Then the Main menu appears. Fibre Channel Hub Model Number: Device Agent Version: Hub Controller Version: Agent Boot PROM Version: Status of Device Agent self-test: Status of Hub Controller self-test: HP3724A 02.04 02.02 01.04 passed passed 1. Reset hub and run self-test 2. Set Networking parameters 5. Verify that the Device Agent and Hub Controller versions you reinstalled appear in the Main menu. 6. See Updating the Hub Firmware on page 48 to upgrade to the new firmware versions. Troubleshooting If Firmware Upgrade Appears to Fail 83