HP T5730 Hardware Reference Guide: HP Compaq t5730/t5735 Thin Clients - Page 24

2. To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1). Figure 2-8 Removing and replacing the internal battery 3. To insert the new battery, slide one edge of the replacement battery under the holder's lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2). HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable batteries. For more information about recycling programs, go to www.hp.com/recycle. Batteries, battery packs, and accumulators should not be disposed of together with the general household waste. In order to forward them to recycling or proper disposal, please use the public collection system or return them to HP, an authorized HP partner, or their agents. The Taiwan EPA requires dry battery manufacturing or importing firms, in accordance with Article 15 or the Waste Disposal Act, to indicate the recovery marks on the batteries used in sales, giveaways, or promotions. Contact a qualified Taiwanese recycler for proper battery disposal. Installing the PCI Expansion Module and PCI Card Before beginning the replacement process, review General Hardware Installation Sequence on page 10 for procedures you should follow before and after installing or replacing hardware. WARNING! Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet. Follow the instructions included in the PCI Expansion Module option kit. CAUTION: Be sure to use the thin client with the stand in the tower mode if the PCI Expansion Module and PCI Card are installed. 18 Chapter 2 Hardware Changes