HP Visualize J7000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 67

Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5000 and J7000 Workstations Ostat Code WRN 7601 FRU DIMM TST 7602 DIMM TST 7603 DIMM TST 7604 DIMM TST 7605 DIMM TST 7606 DIMM TST 7607 DIMM TST 7608 DIMM TST 7609 DIMM TST 760A DIMM TST 760B DIMM WRN 760C DIMM FLT 760D DIMM FLT 7610 DIMM FLT 7611 DIMM FLT 7612 DIMM FLT 7613 DIMM FLT 7614 DIMM FLT 7800 SYS BD FLT 7801 SYS BD Message mem init only tst 1st mem page tst rest of mem start 1st pass 1st pass x% start 2nd pass 2nd pass x% start 3rd pass 3rd pass x% start mem init mem init x% repeat dest test mem code cpy err ECC wrt/read err ECC single data ECC single ECC ECC multipl data ECC multpl signl mem err summary bus ctrl par err Description Skip the test, just initialize memory to save time. Starting 3-pass test of first memory page. Starting 3-pass test of the rest of memory. Starting 1st pass of memory test (write pseudorandom sequence). First pass is x% complete. Starting 2nd pass of memory test (verify pseudorandom sequence, write inverse). Second pass is x% complete. Starting 3rd pass of memory test (verify inverse sequence). Third pass is x% complete. Starting memory initialization. (Initialize to zero to set ECC.) Memory initialization is x% complete. Re-execute destructive test for hardware troubleshooting. Firmware tried to copy code from ROM to memory, but the copy didn't match the original. Writing and reading back good data caused memory ECC error. Memory ECC test failed to detect single-bit data error. Memory ECC test failed to detect single-bit ECC error. Memory ECC test failed to detect multiple-bit data error. Memory ECC test failed to signal multiple-bit error. Printing memory error summary word to RS-232 if in manufacturing mode or if the chassis jumper is installed. System bus (Runway) control parity error detected. Chapter 3 63