HP Visualize b1000 hp Visualize b1000 and c3000 workstations service handbook - Page 70

Troubleshooting Selftest Failures Table 3-2. Chassis Codes for B1000/C3000 Workstations Ostat INI INI INI INI INI FLT FLT FLT INI WRN WRN INI FLT FLT FLT INI TST TST INI WRN FLT TST Code FRU 721s 722s DIMM DIMM 723s 724s 725s 72As DIMM DIMM DIMM DIMM 72Cs DIMM 72Ds DIMM 7300 7302 SYS BD SYS BD 7306 SYS BD 7307 7308 SYS BD SYS BD 7309 DIMM 730C 730F 7400 740F 7500 7501 7502 SYS BD SYS BD DIMM DIMM SYS BD SYS BD SYS BD 7600 DIMM Message Description is DIMM s inst? SPD is checking memory slot s. ???? DIMM in s SPD found a DIMM in slot s, but can't determine its size. DIMM will not be used. 128M DIMM in s SPD found a 128MB DIMM in slot s. 256M DIMM in s SPD found a 256MB DIMM in slot s. 512M DIMM in s SPD found a 512MB DIMM in slot s. DIMM s checksum DIMM in slot s failed SPD checksum and will not be used. DIMM s mismatch DIMM in slot s didn't match the other in pair. (J7000 only--DIMMs must be in matched pairs.) DIMM s load err Memory DIMMs are not in the proper order. As a result, the system cannot access DIMM s and has deallocated it. mem config start Starting main memory configuration. mem confg changd Memory physical configuration changed since last boot. use alt mem conf Memory will be configured from fixed values, instead of detected DIMMs. interleve memory Generating the memory interleave. PDT is disabled Firmware detected bad memory pages, but the Page Deallocation Table is disabled. insufficient mem Insufficient error-free memory to continue. mem intrlv fail Memory interleave generation failed. mem config done Main memory configuration complete. non-dest mem tst Starting non-destructive memory test. non-dst tst done Non-destructive memory test complete. memory reset Resetting memory system. mem log clr warn Memory error logs didn't clear on first try. mem err log fail Firmware could not clear memory error logs. dest mem test Starting the destructive memory test. 70 Chapter 3