HP Visualize b1000 hp Visualize b1000 and c3000 workstations service handbook - Page 71

Troubleshooting Selftest Failures Table 3-2. Chassis Codes for B1000/C3000 Workstations Ostat WRN TST TST TST TST TST TST TST TST TST TST WRN FLT FLT FLT FLT FLT FLT FLT FLT Code FRU 7601 DIMM 7602 7603 7604 DIMM DIMM DIMM 7605 7606 DIMM DIMM 7607 7608 DIMM DIMM 7609 760A DIMM DIMM 760B 760C DIMM DIMM 760D DIMM 7610 DIMM 7611 DIMM 7612 DIMM 7613 DIMM 7614 DIMM 7800 SYS BD 7801 SYS BD Message Description mem init only Skip the test, just initialize memory to save time. tst 1st mem page Starting 3-pass test of first memory page. tst rest of mem Starting 3-pass test of the rest of memory. start 1st pass Starting 1st pass of memory test (write pseudorandom sequence). 1st pass x% First pass is x% complete. start 2nd pass Starting 2nd pass of memory test (verify pseudorandom sequence, write inverse). 2nd pass x% Second pass is x% complete. start 3rd pass Starting 3rd pass of memory test (verify inverse sequence). 3rd pass x% Third pass is x% complete. start mem init Starting memory initialization. (Initialize to zero to set ECC.) mem init x% Memory initialization is x% complete. repeat dest test Re-execute destructive test for hardware troubleshooting. mem code cpy err Firmware tried to copy code from ROM to memory, but the copy didn't match the original. ECC wrt/read err Writing and reading back good data caused memory ECC error. ECC single data Memory ECC test failed to detect single-bit data error. ECC single ECC Memory ECC test failed to detect single-bit ECC error. ECC multipl data Memory ECC test failed to detect multiple-bit data error. ECC multpl signl Memory ECC test failed to signal multiple-bit error. mem err summary Printing memory error summary word to RS-232. bus ctrl par err System bus (Runway) control parity error detected. Chapter 3 71