HP Xw460c Mezzanine Card Installation Instructions for supported HP ProLiant c - Page 1
HP Xw460c - ProLiant - Blade Workstation Manual
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Mezzanine Card Installation Instructions for supported HP BladeSystem c-Class server blades © Copyright 2006 - 2007 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. April 2007 (Second Edition) Part Number 413773-022 Overview Use these instructions to install optional mezzanine cards. Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The type of the mezzanine card determines where it can be installed in the server blade. Install Type I mezzanine cards on Mezzanine 1 connector, Mezzanine 2 connector, or Mezzanine 3 connector. Install Type II mezzanine cards on either Mezzanine 2 connector or Mezzanine 3 connector. Warnings and cautions WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them. WARNING: Reduce the risk of electric shock by removing all AC power from the system before installing or replacing any non-hot-plug hardware option. Disconnect all power cords to completely remove power from the server. CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly grounded (earthed) before beginning any installation procedure. CAUTION: Limit the number of times that a mezzanine card is installed and removed within its lifecycle to prevent connector pin damage. Removing the access panel 1. Identify the proper server blade in the enclosure. 2. Back up all server blade data. 3. Power down the server blade. 4. Remove the server blade. 5. Lift the access panel latch and slide the access panel to the rear. 6. Remove the access panel. Installing the mezzanine card IMPORTANT: Remove the mezzanine card connector protective cover, if installed.