HP Xw460c Mezzanine Card Installation Instructions for supported HP ProLiant c - Page 2

1. Install the mezzanine card as shown below. Or, for half-height server blades install as shown. European Union regulatory notice This product complies with the following EU Directives: • Low Voltage Directive 2006/95/EC • EMC Directive 2004/108/EC Compliance with these directives implies conformity to applicable harmonized European standards (European Norms) which are listed on the EU Declaration of Conformity issued by Hewlett-Packard for this product or product family. This compliance is indicated by the following conformity marking placed on the product: This marking is valid for non-Telecom products and EU harmonized Telecom products (e.g. Bluetooth). 2. Reinstall the access panel. NOTE: See the HP BladeSystem Enclosure Setup and Installation Guide for more information on the association between the mezzanine bay and the interconnect bays. Where you install the mezzanine card will determine where you need to install the interconnect modules. 3. Restore the server blade to its operating position in the server blade enclosure. NOTE: By default, the server blade will power up on installation. Completing the installation For information about installing and configuring drivers for your specific operating system and mezzanine card refer to the HP website (http://www.hp.com/go/bladesystem/mezzanines). This marking is valid for EU non-harmonized Telecom products. *Notified body number (used only if applicable-refer to the product label) Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, Germany Korean class A notice