HP Xw460c Remote Graphics Software 5.2.5 User Guide - Page 155
Sender general properties, Rgsender.IsCopyRegionEnabled, Rgsender.IsRegionLimitEnabled
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
• USB access control list properties group • Rgsender.Usb.Acl.RulesetPath • Rgsender.Usb.Acl.SchemaPath • Rgsender.Usb.Acl.RulesetErrorTimeout • NIC binding properties group • Rgsender.Network.IsListenOnAllInterfacesEnabled • Rgsender.Network.Interface.n.IsEnabled • Rgsender.Network.AllowIpAddressSubnet • Rgsender.Network.Port • Clipboard property group • Rgsender.Clipboard.IsEnabled 8-6-2 Sender general properties Rgsender.IsRdpLogoutDetectionEnabled=bool (1) This property only applies to the Windows versions of the RGS Sender. When a user disconnects from a Remote Desktop Protocol (RDP) session, the Windows desktop on the Remote Computer is immediately available for an RGS connection. However, if the user logs out of the RDP session, the RGS Sender will be unable to access the desktop for about 60 seconds. If this property is set to 1, the desktop will be available to RGS almost immediately. The RGS Sender will monitor the RDP session for a logout, and begin the process of making the desktop available as soon as the logout is detected. If set to 0, the RGS Sender will not monitor the RDP session for a logout. The default is 1-allow quick access to the Windows desktop after Remote Desktop logout. Rgsender.IsCopyRegionEnabled=bool (1) If set to 1, RGS Copy Regions are sent from the Sender to the Receiver. If set to 0, RGS Copy Regions are turned off and will be sent to the Receiver as Image Update Regions. This is for advanced use and should not be set. The default value is 1-send RGS Copy Regions. Rgsender.IsRegionLimitEnabled=bool (0) This property is used to limit the number of update rectangles in a update region. This is for advanced use and should not be set. The default value is 0-don't limit regions. Rgsender.IsDisconnectOnLogoutEnabled=bool (1) If set to 1, the RGS connection will be disconnected when the user logs out. If set to 0, the RGS connection will remain connected to the Sender when the user logs out. The default value is 1-always disconnect when the user logs out. Rgsender.IsSnapToCodecEnabled=bool (1) If set to 1, the HP Codec will be aligned or snapped to tile boundaries. This will avoid persistent visual artifacts at the expense of potentially increased bandwidth usage. If set to 0, the alignment of the codec with respect to the screen will be arbitrary, as determined by the exposed or modified region. For user desktops that contain primarily 2D applications, turning off this property can save network bandwidth. The default value is 1-always snap the codec to tile boundaries. RGS properties 155