HP Xw460c Remote Graphics Software 5.2.5 User Guide - Page 72
Disabling the Sender GUI on Linux, noautostartgui
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Disabling the Sender GUI on Linux The Sender GUI on Linux automatically starts when the Sender process starts. To prevent the Sender GUI from automatically starting, edit the file /opt/hpremote/rgsender/rgsender.sh, and add the -noautostartgui command line option as follows: exec ./rgsender $* -noautostartgui -l logSetup As described immediately above under the noautostartgui command line option, the Sender GUI can be started subsequently by the user. Uninstalling the Sender on Linux To uninstall the RGS Sender on Linux, perform the following steps: 1. Log in as root. 2. If the default install.sh was used, then the following command should report some variation of the following packages: # rpm -qa | grep -i rgsender rgsender_linux_64-5.1.0-1 rgsender_config_64-5.1.0-1 3. To remove the rgsender package (and corresponding configuration rpm if used), execute the command: rpm -e --allmatches rgsender_linux_64 rgsender_config_64 4. If the rgsender_config_64-*.rpm was installed, it must be removed first (or together as demonstrated above) before removing the rgsender_linux_64-*.rpm package. This resolves dependencies between the packages, and undoes the previous customizations performed by this rpm. If you are upgrading your system from a previous version of RGS, it is suggested that you remove both packages, and then apply the new software rpms for supported results. Installing RGS 72