HP Xw6600 HP Workstations - LSI SAS 3041E Serial Attached SCSI RAID - Page 7
Connecting the LED activity indicator
UPC - 883585731121
View all HP Xw6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. Select the data cable for the workstation from those shipped with the hard drive. a. Connect one end to port 0 on the SAS RAID controller card . b. Attach the other end of the data cable to the data cable connector on the primary hard drive 2. Figure 7 Attaching the data cable 3. Attach any subsequent hard drives to ports 1-3 on the RAID controller card. Figure 8 RAID controller ports 4. Continue with Connecting the LED activity indicator on page 7. Connecting the LED activity indicator This section applies to all HP workstations shown above. Attach one end of the hard drive activity LED cable to the RAID controller card. Attach the other end of the hard drive activity LED cable to the hard drive LED activity connector on the system board 2. (An HP xw6000 series workstation system board is shown in the illustration for reference.) NOTE: To locate the hard drive activity LED (HDD-LED) connector on the system board, see the service label inside the workstation side access panel. Use the LED cable appropriate for the workstation. ENWW Step 3-Configuring the cabling 7