HP Xw6600 HP xw Workstation series - SAS/SATA hard drive installation - Page 3
Preparing for installation, Tools required, Precautions for handling the drive
UPC - 883585731121
View all HP Xw6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal object. CAUTION: Observe the following cautions when removing or replacing a processor: - Installing a processor incorrectly can damage the system board. Have an HP authorized reseller or service provider install the processor. If you plan to install it yourself, read all of the instructions carefully before you begin. - Failure to follow the workstation preparation instructions and these result in an improperly installed processor, causing extensive system damage. - Processor socket pins are delicate and bend easily. Use extreme care when placing the processor in the socket. CAUTION: To prevent damage to this system, observe the following Electro Static Discharge (ESD) precautions while performing the system parts removal/replacement procedures: - Work on a static-free mat. - Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body to the ground. - Create a common ground for the equipment you are working on by connecting the static-free mat, static strap and peripheral units to that piece of equipment. NOTE: HP accessories are for use in HP workstation products. They have been extensively tested for reliability and are manufactured to high quality standards. HP, therefore, warrants only those accessories that are manufactured or sold by HP. Preparing for installation Before beginning installation of the drive, ensure that the installation kit contains all necessary items, that you have the required tools, that you understand the necessary precautions, and that you have prepared the workstation, as described in the following subsections. Tools required You may need the following to install the hard drive: ● Torx T-15 screwdriver or flat-bladed screwdriver Precautions for handling the drive Observe all precautions when handling the drive, as listed below: ● Do not move the drive during operation. Doing so may cause it to malfunction during reading. ● Avoid placing the drive in a location that is subject to extreme temperatures, or mechanical vibration. ENWW Preparing for installation 3