HP Z Display Z34c User Guide 1 - Page 35
Entering user modes, Power adapter
View all HP Z Display Z34c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
NOTE: The host computer or source device attached to the monitor can drive the monitor to its native resolution at 60Hz refresh using only the DisplayPort interface. If using HDMI, the monitor is limited to a refresh rate of 30Hz at native resolution, as defined in the HDMI 1.4 standard. The monitor will convert up to 60Hz refresh. Some MHL supported devices and some HDMI Blu-Ray supported media players support full high definition resolution at 24 frames per second. The monitor supports this display resolution mode and will convert up to 60Hz refresh. Entering user modes The video controller signal may occasionally call for a mode that is not preset if: ● You are not using a standard graphics adapter. ● You are not using a preset mode. If this occurs, you may need to readjust the parameters of the monitor screen by using the on-screen display. Your changes can be made to any or all of these modes and saved in memory. The monitor automatically stores the new setting, and then recognizes the new mode just as it does a preset mode. In addition to the factory preset modes, there are at least 10 user modes that can be entered and stored. Power adapter Manufacturer Delta Electronic(S) Pte Ltd Chicony Electronics CO, Ltd Part number HP PN 681058-00x HP PN 681058-00x Power supply rating 150W 19.5VDC 150W 19.5VDC Power adapter 29