HP Z200 Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card instal
HP Z200 - Small Form Factor Workstation Manual
View all HP Z200 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Z200 manual content summary:
- HP Z200 | Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card instal - Page 1
use of any product. To determine the compatibility of this product with your computer or workstation, view QuickSpecs at http://www.hp.com/ go/productbulletin. The Broadcom NetXtreme Gigabit Ethernet Plus NIC is enabled with Desktop and mobile Architecture for System Hardware (DASH), a new remote IT - HP Z200 | Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card instal - Page 2
at all times. - Disconnect power from the equipment by unplugging the power cord from the electrical outlet. WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper computer setup, posture, health, and work habits for computer users, and provides important - HP Z200 | Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card instal - Page 3
the system BIOS updates, if available. Accessing the internal components of the computer 1. If you need help preparing the computer for this installation, consult the removal and replacement procedures in the service guide for your computer at http://www.hp.com/support/manuals. 2. Power down the - HP Z200 | Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card instal - Page 4
levers (2). Figure 2 Installing the NIC 3. For computers that support DASH, attach the USB cable provided to the USB connector on the NIC (3), and then to the DASH-enabled USB dual (10-pin) header on the system board (4). NOTE: To locate the DASH-enabled USB, see the service label inside the side - HP Z200 | Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card instal - Page 5
instructions on installing NIC software, see the driver CD supplied with this installation kit. NOTE: At the time of component installation, look for device software, firmware, and driver updates, designated for your computer model and operating system. Obtain updates from http://www.hp.com/ support - HP Z200 | Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card instal - Page 6
available in Japanese. See http://www.hp.com/support/manuals, then select your product and select Japanese from the drop down Manual Language menu. http://www.hp.com/support/manuals Manual Language Japanese 6 Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card installation ENWW
Broadcom NetXtreme Gigabit Ethernet Plus
Network Interface Card installation
Introduction
This document describes how to install a Broadcom NetXtreme Gigabit Ethernet Plus Network Interface
Card (NIC) into a PCI Express (PCIe) slot on your computer.
Kit contents
●
Broadcom NetXtreme Gigabit Ethernet Plus NIC
●
USB cable
●
Low-profile bracket
●
Broadcom NetXtreme driver and application CD
●
Warranty information
●
Installation instructions
Your responsibilities
You are responsible for determining whether the product is appropriate for your use and will interface
with other equipment without malfunction or damage. You are also responsible for backing up data
before installing any product and for regularly backing up data after installing the product. HP is not
liable for any damage to equipment or data loss resulting from the use of any product. To determine the
compatibility of this product with your computer or workstation, view
QuickSpecs
at
go/productbulletin
.
The Broadcom NetXtreme Gigabit Ethernet Plus NIC is enabled with Desktop and mobile Architecture
for System Hardware (DASH), a new remote IT management tool for desktop and mobile computers.
In some computers, the functionality of the DASH feature might be mutually exclusive with some internal
USB accessories, like the HP Media Reader.
© 2009, 2010 Hewlett-Packard Development Company, L.P. Printed in the U.S.
ENWW
Introduction
1