HP Z220 HP Workstations - CRU Dataport DX115 kit installation - Page 22
HP Z220 Manual
View all HP Z220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
2. Connect the power (1) and data (2) cables to the primary (upper) ports on the unit. Figure 30 Power and data ports 3. Connect the opposite end of the data cable to the appropriate connector on the system board or controller card. ● ● Connect SATA drives to SATA ports, and SAS drives to SAS ports, starting with the lowestnumbered available port. For HP Z400 and Z600 computers, the blind-mate cables for the internal hard drive bays may require adjustment at the system board, based on the computer drive configuration. Consult the User Guide or the Maintenance and Service Guide for your computer for additional information. 4. 5. 6. 7. 8. 9. To prepare your installed hard drive for operation, see the appropriate hard drive documentation. Replace the computer bezel and bezel security screw, if applicable. Reinstall the card support, if applicable. Reinstall the airflow guide, if applicable. Reinstall the side access panel. Reconnect all external devices. 10. Restore power to the computer and all external devices. Japanese 日本語 This document is available in Japanese. See http://www.hp.com/support/manuals, then select your product and select Japanese from the drop down Manual Language menu http://www.hp.com/support/manuals Manual Language Japanese 18 CRU Dataport DX115 kit installation ENWW