HP Z600 CRU Dataport DX115 kit Installation - Page 9
Step 4—Completing the workstation assembly, User Guide
UPC - 884962074053
View all HP Z600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Step 4-Completing the workstation assembly CAUTION: Insert or remove the carrier (with a disk drive) only when the workstation is shut down. Other procedures may result in system hangs, data loss, or even drive damage. The component supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the workstation is booted and then powering the drive via the power switch on the enclosure. Microsoft Windows XP and Windows Vista do not support this action. 1. After the drive is installed in the carrier, insert the drive carrier in the case. a. Press the handle in . b. Use the key 2 to lock the carrier if shipping the unit . 2. Connect the power and data 2 cables to the primary (upper) ports on the unit. 3. Connect the opposite end of the data cable to the appropriate connector on the system board or controller card. ● Connect SATA drives to SATA ports, and SAS drives to SAS ports, starting with the lowestnumbered available port. ● For HP 400 and 600 Workstations, the blind-mate cables for the internal hard drive bays may require adjustment at the system board, based on the workstation drive configuration. Consult the User Guide for your workstation for additional information. ENWW Step 4-Completing the workstation assembly 9