HP c3700 hp workstations - HP A7789A Fire GL UX Graphics Card And Software - Page 7

Figure 0-4 Removing the I/O Card Retainer I/O Card I/O Card Retainer Air Divider 3. Locate the card you want to remove and, using the T-15 Torx driver, remove the I/O card's bulkhead screw as shown below:. Figure 0-5 Removing the I/O Card I/O Card Bulkhead Screw I/O Card Bulkhead I/O Card Being Removed 4. Pull evenly on the outside edges of the I/O card to remove it. To install a card into your system unit, follow these steps. 1. Locate the appropriate slot for the I/O card that is to be installed. 2. Insert the card into the slot you have chosen with the bulkhead appropriately positioned. See above. The non-bulkhead end of the card should be placed in the card guide. Press firmly and evenly on the card until it is seated in the connector. Screw the T-15 Torx screw into the card's bulkhead (using 6 inch-pounds of torque) to secure the card. 3. Replace the card retainer by placing the bottom retainer hook in the slot on the air divider and the clips on the PULL tabs into their slots on the chassis wall. 4. Close the left side panel of the system unit by following the procedure in the User's Guide. Also refer to your workstation documentation for instructions on using the HP-UX System Administration Manager (SAM) utility to verify your graphics configuration