HP dc72 Hardware Reference Guide - dc7700 SFF - Page 39

Disengaging the 3.5-inch Drive Diskette Drive shown

Get HP dc72 - Blade Workstation Client PDF manuals and user guides View all HP dc72 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

3. Press the green drive retention latch (1) located on the side of the drive to disengage the drive from the drive cage and slide the drive forward approximately 1/4 inch (6 millimeters) (2). Figure 2-25 Disengaging the 3.5-inch Drive (Diskette Drive shown) 4. Lift the rear of the drive up so that the rear guide screws clear the top of the drive cage (1). As the drive rises it automatically slides forward until it is free from the drive cage (2). Figure 2-26 Removing a 3.5-inch Drive (Diskette Drive shown) NOTE To replace the 3.5-inch drive, reverse the removal procedure making sure you slide the front guide screws into the cage first then rotate the rear of the drive down and slide it back until it locks into position. When replacing a 3.5-inch drive, transfer the four guide screws from the old drive to the new one. ENWW Installing and Removing Drives 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
3.
Press the green drive retention latch (1) located on the side of the drive to disengage the drive from
the drive cage and slide the drive forward approximately 1/4 inch (6 millimeters) (2).
Figure 2-25
Disengaging the 3.5-inch Drive (Diskette Drive shown)
4.
Lift the rear of the drive up so that the rear guide screws clear the top of the drive cage (1). As the
drive rises it automatically slides forward until it is free from the drive cage (2).
Figure 2-26
Removing a 3.5-inch Drive (Diskette Drive shown)
NOTE
To replace the 3.5-inch drive, reverse the removal procedure making sure you slide the
front guide screws into the cage first then rotate the rear of the drive down and slide it back until
it locks into position.
When replacing a 3.5-inch drive, transfer the four guide screws from the old drive to the new one.
ENWW
Installing and Removing Drives
33