HP rp4440 HP DLPI Programmer's Guide - Page 135
Parameters, State, New State, Response, The resulting state is DL_CONN_RES_PENDING.
View all HP rp4440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Chapter 2 DLPI Primitives Connection-mode Service Primitives ulong dl_qos_offset; ulong dl_growth; } dl_connect_res_t; Parameters dl_primitive DL_CONNECT_RES dl_correlation correlation number that was received with the DL_CONNECT_IND associated with the connection request. The DLS provider will use the correlation number to identify the connect indication to which the DLS user is responding. dl_resp_token if non-zero, the token associated with the responding stream on which the DLS provider is to establish the connection; this stream must be attached to a PPA and bound to a DLSAP. dl_qos_length length of the quality of service parameter. This should be the same parameter specified in the DL_CONNECT_IND. dl_qos_offset offset from the beginning of the M_PROTO message block where the quality of service parameters begin. dl_growth growth field for future enhancements to this primitive. Its value will be set to zero. State The primitive is valid in state DL_INCON_PENDING. New State The resulting state is DL_CONN_RES_PENDING. Response If the connect response is successful, DL_OK_ACK is sent to the DLS user. If no outstanding connect indications remain, the resulting state for the current stream is DL_IDLE; otherwise, it remains 135