Hitachi 42HDM12 Owners Guide - Page 13

FRONT PANEL CONTROLS FRONT VIEW 42" PLASMA MONITOR ① REMOTE CONTROL sensor Point your remote control at this area when selecting signal, adjusting volume, etc. ② POWER light indicator To turn the PDP MONITOR ON, press the main power button located on the BACK left side of the monitor. A red stand-by indicator lamp located on the lower right corner of the front bezel will illuminate. The PDP monitor is now ready for remote on/off operation. Indicating Lamp Off Lights Red Lights Orange Lights Green Power Status Off Off (Stand-by) Off (Power Saving) On Operating When the MAIN POWER is set OFF. When the MAIN POWER is set ON and the Front Key or Remote Control POWER is OFF. 1. When the MAIN POWER is set ON. 2. No signal input (no sync. signal). When the POWER is ON. ③ POWER button This power button is for power on the plasma monitor or change to standby mode. ④ À and · selector These buttons serve as the cursor down (À) and up (·) buttons when in MENU mode. ⑤ VOLUME level Press these buttons to adjust the sound level. The volume level will be displayed on the monitor screen. These buttons also serve as the cursor left (W) and right (X) buttons when in MENU mode. ⑥ INPUT/EXIT button Press this button to select the desired input: Composite-VIDEO, S-VIDEO, YCBCR, YPBPR, Analog RGB or HDMI source. This button also serves as the EXIT button when in MENU mode. ⑦ MENU/SELECT button This button allows you to enter the MENU, making it possible to set monitor features to your preference without using the remote. This button also serves as the SELECT button when in MENU mode. 12