Hitachi CML174SXW User Manual - Page 14

ENGLISH Chapter 1 Installation Unpacking Before unpacking the LCD Monitor, prepare a suitable workspace for your Monitor and computer. You need a stable and clean surface near a wall power outlet. Make sure that the LCD Monitor has enough space around it for sufficient airflow. Though the LCD Monitor uses very little power, some ventilation is needed to ensure that the Monitor does not become too hot. After you unpack the LCD Monitor, make sure that the following items were included in the box: * LCD Monitor * 1.8M Monitor-to-PC VGA Cable * 1.8M Monitor-to-PC DVI-D Cable * 1.8M Power Cord * User's Manual If you find that any of these items is missing or appears damaged, contact your dealer immediately. Viewing Angle Adjustment The LCD Monitor is designed to allow the users to have a comfortable viewing angle. The viewing angle can be adjusted as follows: Top (-5°~ +30°). WARNING Figure 1-1 Do not force the LCD Monitor over the maximum viewing angle settings as stated above. In such an event, you will damage the Monitor and a Monitor stand. Connecting the Display to your Computer 1. Power off your computer. 2. Connect one end of the signal cable to the LCD Monitor's VGA port or DVI port. (See Fig. 1-2) 3. Connect the other end of the signal cable to the VGA port or DVI port on your PC. 4. Make sure both connections are secure. Figure 1-2 ATTENTION This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations. A ferrite-loaded interface cable is included in the LCD Monitor package. This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used. 13