Hitachi CP-X3010 Operation Guide - Page 15

Operating Operating Adjusting the volume VOLUME +/- button 1. Use the VOLUME +/VOLUME - buttons to adjust the volume. A dialog will appear on the screen to aid you in adjusting the volume. If you do not do anything, the dialog will automatically disappear after a few seconds. ● When is selected for current picture input port, the volume adjustment is disabled. Please see AUDIO SOURCE item of MY SOURCE/ VIDEO COMPUTER DOC.CAMERA ASPECT AUTO SEARCH BLANK MAGNIFY FREEZE PAGE VOLUME ON UP 㧗 DOWN OFF ࡯ KEYSTONE MY BUTTON MUTE 1 2 AUDIO menu (36). POSITION MENU ● When the projector is in the standby mode, the volume can be ENTER adjusted if is not selected for the AUDIO OUT STANDBY and NOESRC MAL isRESET selected to the STANDBY MODE in the SETUP menu (35). Temporarily muting the sound 1. Press MUTE button on the remote control. A dialog will appear on the screen indicating that you have muted the sound. To restore the sound, press the MUTE, VOLUME + or VOLUME - button. Even if you do not do anything, the dialog will automatically disappear after a few seconds. MUTE button MY SOURCE/ VIDEO COMPUTER DOC.CAMERA ASPECT AUTO SEARCH BLANK MAGNIFY FREEZE PAGE VOLUME ON UP 㧗 DOWN OFF ࡯ KEYSTONE MY BUTTON MUTE 1 2 ● When is selected for current picture input port, the sound is always muted. Please see AUDIO SOURCE item of POSITION MENU AUDIO menu (36). ENTER ESC RESET ● C.C. (Closed Caption) is automatically activated when sound is muted and an input signal containing C.C is received. This function is available only when the signal is NTSC for VIDEO or S-VIDEO, or 480i@60 for COMPONENT, COMPUTER IN1 or COMPUTER IN2, and when AUTO is selected for DISPLAY in the C.C. menu under the SCREEN menu (41).   Selecting an input signal 1. Press INPUT button on the projector. Each time you press the button, the projector switches its input port from the current port as below. COMPUTER IN 1  COMPUTER IN 2 VIDEO S-VIDEO COMPONENT (Y, Cb/Pb, Cr/Pr) ● While ON is selected for AUTO SEARCH item in OPTION menu (42), the projector will keep checking the ports in above order repeatedly till an input signal is detected. INPUT button (continued on next page) 15