Hitachi DS18DSAL Instruction Manual - Page 15
Install securely the hook. Unless the hook is securely - driver drill only
UPC - 717709013773
View all Hitachi DS18DSAL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English ⅷ When carrying the power tool with hooked to your waist belt, do not fit any bit to the tip of power tool. If the sharp bit such as drill is fitted to the power tool when carrying it with hooked to your waist belt, you will be injured. ⅷ Install securely the hook. Unless the hook is securely installed, it may cause an injury while using. 11. Using the light Pull the trigger switch to light up the light. The light keeps on lighting while the trigger switch is being pulled. The light goes out after releasing the trigger switch. (Fig. 12) (1) Removing the hook. Remove the screws fixing the hook with Philips screw driver. (Fig. 10) Light Trigger switch Fig. 12 Fig. 10 Screw Hook (2) Replacing the hook and tightening the screws. Install securely the hook in the groove of power tool and tighten the screws to fix the hook firmly. (Fig. 11) CAUTION: Do not look directly into the light. Such actions could result in eye injury. 12. The scope and suggestions for uses The usable scope for various types of work based on the mechanical structure of this unit is shown in Table 5. Screw Hook Fig. 11 Drilling Screw tightening Work Wood Steel Aluminum Small screw Wood screw Table 5 Clutch dial position Suggestions Use for drilling purpose. 1 - 22 1 - Use the bit and socket matching the screw diameter. Use after drilling a pilot hole. 15