Hitachi DV-PF33U Owners Guide - Page 16

H9450UD(EN).qx33 03.1.22 7:19 PM Page 16 REMOTE CONTROL OF THE TV You can use the DVD/VCR remote control to control your TV by following the steps below. PROGRAMMING THE REMOTE CONTROL FOR THE TV 1 Turn off the TV. CONTROLLING THE TV Once programmed, the DVD/VCR's remote control is ready to control the TV. NOTE: Be aware that not all of your TV's functions may work even though the remote control is correctly programmed. 2 Program the remote control Aim the DVD/VCR's remote control at your TV set. Hold down the TV POWER button while you press the number corresponding to your brand of television as shown in the chart. For example; If you have a Hitachi television, press the TV POWER and 1 at the same time. If this button combination sends a signal that matches with your TV, the TV will turn on, and you'll know the remote is set to control the television. To operate the TV Always select the TV mode by pressing TV before using the DVD/VCR remote as your TV's remote control. ¡You can turn on your TV by pressing the TV POWER button. ¡You can change the channels with the TV CH (o/p) and the volumes with VOL (o/p) . NOTES: ¡If that button combination does not change the TV channel, go through the whole list of button combinations one by one until you find one that does change your TV channel. ¡Also, if your brand of TV is not listed in the chart, try all the number buttons. One of them may work for you. ¡If the TV channel still doesn't change after going through all the button combinations listed, it is likely that you will not be able to program this remote control for your TV. To operate the DVD/VCR Press the VIDEO/TV to operate your DVD/VCR with the remote. NOTE: VIDEO/TV button is not corresponded to TV which can switch to TV input mode directly. TV Brands HITACHI SONY RCA SANYO ZENITH PANASONIC1 PANASONIC2 SHARP1 SHARP2 TOSHIBA JVC MITUBISHI MAGNAVOX FUNAI GOLDSTAR Press the TV and This Number 1 2 3 4 5 6 7 8 9 0 CLEAR +10 SUBTITLE AUDIO DISPLAY - 16 - EN 21CL025