Hitachi DV18DCL Handling Instructions - Page 7

SPECIFICATIONS POWER TOOL Model DV14DCL2 No-load speed (Low/High) 0 - 400 / 0 - 1500 min-1 No-load impact rate (Low/High) 0 - 5600 / 0 - 21000 min-1 Brick (Depth 30 mm) 13 mm Drilling Wood (Thickness 18 mm) 32 mm Capacity Metal (Thickness 1.6 mm) 13 mm Machine screw Driving Wood screw 6 mm 8 mm (diameter) × 50 mm (length) (Requires a pilot hole) Rechargeable battery BCL1415: Li-ion 14.4 V (1.5 Ah 4 cells) Weight 1.5 kg DV18DCL2 0 - 400 / 0 - 1500 min-1 0 - 5600 / 0 - 21000 min-1 13 mm 38 mm 13 mm 6 mm 8 mm (diameter) × 75 mm (length) (Requires a pilot hole) BCL1815: Li-ion 18 V (1.5 Ah 5 cells) 1.6 kg CHARGER Model Charging voltage Weight UC18YKL 7.2 - 18 V 0.4 kg STANDARD ACCESSORIES In addition to the main unit (1), the package contains the accessories listed in the table below. 1 Plus driver bit (No. 2 × 65L 1 DV14DCL2 DV18DCL2 2 Charger 1 3 Plastic case 1 Standard accessories are subject to change without notice. OPTIONAL ACCESSORIES (sold separately) 1. Battery (BCL1415) (For DV14DCL2) 2. Battery (BCL1815) (For DV18DCL2) Optional accessories are subject to change without notice. APPLICATIONS ○ Drilling of brick and concrete block, etc. ○ Driving and removing of machine screws, wood screws, tapping screws, etc. ○ Drilling of various metals. ○ Drilling of various woods. CHARGING Before using the power tool, charge the battery as follows. 1. Connect the charger's power cord to the receptacle. When connecting the plug of the charger to a receptacle, the pilot lamp will blink in red (At 1-second intervals). 2. Insert the battery into the charger. Firmly insert the battery into the charger till it contacts the bottom of the charger and checking the polarities as shown in Fig. 3. CAUTION If the batteries are inserted in the reverse direction, not only recharging will become impossible, but it may also cause problems in the charger such as a deformed recharging terminal. 3. Charging When inserting a battery in the charger, the pilot lamp will light up continuously in red. When the battery becomes fully recharged, the pilot lamp will blink in red (At 1-second intervals). (See Table 1) (1) Pilot lamp indication The indications of the pilot lamp will be as shown in Table 1, according to the condition of the charger or the rechargeable battery. BATTERY REMOVAL/INSTALLATION 1. Battery removal Hold the handle tightly and push the battery latch (2 pcs.) to remove the battery (see Figs. 1 and 2). CAUTION Never short-circuit the battery. 2. Battery installation Insert the battery while observing its polarities (see Fig. 2). 7